Project files: Little helpers – Alps PCBs III

What is it?
These are “little helper” boards for the Alps RK168xx series of motorised potentiometers. These pots are not quite as good quality as the standard Alps “Blue Velvet” RK27-series, but they are cheaper and smaller. They are also used in many commercial products, so they should work fine for many diy projects. The motor also means that the pots have a nice mechanical feel to them 🙂
There are two board versions, a 2-channel (for stereo with the RK16812) and a 4-channel (for balanced amps with the RK16814). Alps also makes a six-channel version of the pot and adjusting the footprint to fit these should be relatively easy, but I have no need for these now so I couldn’t be bothered 🙂

How big are the boards?
Both boards measure 1.85″ x 2.0″ (app. 47 x 51 mm) and the rear mounting holes are in the same place on both boards.

What is the status of the boards?
Both are version 1.0 since they are exactly as my prototypes.

Does it use any special/expensive/hard-to-find parts?
Mostly there’s only one real part on the board and that is the pot itself, so not really 😀

Anything else I need to know?

  • These are “preamp” style boards have a ground plane and a ground pad that can be used if you grounding scheme requires the shaft of the pot to be grounded. Use a piece of wire connected from the ground pad to either one of the screws on the back of the pot or soldered to a ring terminal wedged between the pot and the chassis. You can also use the grounding pad on the bottom instead.
  • The boards can also be used to make separate, passive preamps. In this case, a 10k potentiometer should be used.
  • The screw clamps are standard 5mm pin spacing types, but of course it is possible to solder bare wires to the boards as well.
  • The basic Eagle footprint for the RK168 was one I found in a diyaudio-thread, so I can’t take credit for that. All I have done is modify it to match the Quad-version as well.

Downloads:
Download design files here

Related information:
Note: Always read the “intro post” for additional important information about my designs.

As usual, please remember to consult the manufacturer’s datasheet as well.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: