Project files: The ACP+ clone…

Well, both my ACP+ clone boards are now fully populated with relays and working as expected so I guess it is appropriate to share the design files 🙂

Read more of this post

Reworking the ACP+…

Last weekend was this year’s “Burning Amp” festival in San Francisco. I wasn’t there (it’s a bit far from Denmark for a weekend trip…), but as usual there was a thread on diyaudio.

Burning Amp has frquently been a “launchpad” for new Nelson Pass designs and this year was no exception – the Amp Camp Pre (ACP+) was shown and the article is now on the FirstWatt website. As usual when Nelson releases a new design you sit up and take notice, but this one was just what I wanted to see (because there is only so many 25W class A amps you can use 😉 ). The ACP+ is a discrete preamp/headphone amp with the same basic architecture as a Pass J2 power amplifier. It’s discrete, doesn’t use a lot of components and runs from a single supply. The only fly in the proverbial ointment is that the amp uses P-channel JFETs for the input (either 2SJ74 or LSJ74), which are either impossible to get (2SJ) or just plain expensive (LSJ). However, I’m certainly not going to let that minor inconvenience stop me.

Nelson has of course done a board for the ACP+ already which will eventually find its way to the diyaudio store I’m sure. However, the original board breaks one of my rules because it has connectors on two edges. It also doesn’t look like the onboard RCAs are particularly good quality. As usual (I am tempted to say) I prefer a more modular approach, with the power supply, the amplifier, the volume pot etc. separated and so as I’ve done in the past I am going to have a go at redoing the ACP+ in modules instead. When I dig into the design I am sure i will be tempted to add a few changes, but let’s see. I expect I am going to build the original proposed linear supply, but an obvious candidate (in my mind) is a filtered IRM-module.

PCB order (hopefully) going out shortly, so with the usual shipping lead time this is going to be my X-mas present for myself this year 🙂

Picture of the prototype amp from the diyaudio-thread.